Hyper-V - Virtualization Enabled in Firmware Yes Hyper-V - Second Level Address Translation Extensions Yes Virtualization-based security Not enabledĭevice Encryption Support Reasons for failed automatic device encryption: PCR7 binding is not supported, Hardware Security Test Interface failed and device is not Modern Standby, Un-allowed DMA capable bus/device(s) detected, TPM is not usable Hardware Abstraction Layer Version = '2.10000' Processor Intel(R) Core(TM) i5-2400 CPU 3.10GHz, 3101 Mhz, 4 Core(s), 4 Logical Processor(s)īIOS Version/Date Hewlett-Packard J01 v02.29, 'Trying to record using AWaveStudio and I get this error message check below also my vb cable are setup accordingly please let me know if its not configured correctly thank you' Hello everyone this is my very first Post after reading most of the instruction on setting up VBcable I have set my cable as explained in the help guide step by step the free version but suddenly a few weeks later no sound through my Free VB-Cable, I decided to do a clean install removing anything that might be in my registry a fresh install but decided to donate and go with VB Cable A /B I try to setup as the free version settings but no sound coming out of either Cables A/B can someone explain to me how to fix this? could this be a cause from a MS update below are my system specs I have two AV installed I have disable both of them and re-enable them but still no sound coming out from them accept my regular windows driver ->

Vb audio virtual cable